Get correct colour reproduction in MATRIX control prints
By default, MATRIX control panels come with full intensity on all RGB LEDs. However, for better colour reproduction, the intensity of the three channels (R, G and B) should be "calibrated" in the configuration parameter for common RGB level control.
Configuration parameter #14 (4 byte parameter) should be set to the following value:
| Description | Value | |
| Byte 1: Light level for red | Specifies the common level of the red LEDs (default value is 255) | Must be set to 255 |
| Byte 2: Light level for green | Specifies the common level of the green LEDs (Default value is 255) | Must be set to 85 |
| Byte 3: Light level for blue | Specifies the common level of the blue LEDs (default value is 255) | Must be set to 85 |
| Byte 4: Not used | (Default value is 0) | Must be set to 0 |
This gives the following 4-byte hex value: FF55 5500
Or decimal value: 4.283.782.400 (in some systems it should be entered as -11,184,896)
If the change is to be made in Fibaro Home Centre, you can see how to set a configuration parameter in the guide below:
Do you need help?
If you need help with your Logic Group smart home, contact our electrician and smart home specialist
Direct email: nhy@logic-group.com
NICKLAS HYLLEBERG+45 21 89 53 43